| Specifications: |
| Hub Weight: 23.5 Pounds |
| Hub Width: 75mm / 2.96" |
| Top Speed: 24-30 MPH |
| Range: See Batteries |
| Controller: 40A |
| Power: |
36V (1400W)* or
48V (1900W)* |
|
Crystalyte Phoenix Cruiser Bike Kit
The Crystalyte Phoenix Cruiser (or 5304) is
an extremely powerful direct-drive motor designed
for torque and speed. Available in a front or rear
mounted 20", 24", 26" or 700c wheel, this kit
includes everything you need except for batteries.
Choose our pre-built SLA battery pack, purchase
a wiring kit to build your own (and save), or use
the 36V or 48V battery pack of your choice.
Order this kit with a pre-wired SLA battery pack (and charger) or choose a wiring kit to use your own SLA batteries. You'll get: wiring instructions, jumpers, fuse holder, 40A fuse, key switch, charger port, 50A Anderson and terminal connectors. Just add 12V SLA batteries! Front wheel kit includes torque arm, rear gets 7-speed freewheel.
Crystalyte Phoenix Kit Includes:
- 1 x 1000W Direct-Drive (Gearless) Hub Motor (1400w/1900w output)
- 1 x Double Walled Rim w/ 12 Guage Spokes
- 1 x 36V / 48V 40 Amp Intelligent Motor Controller
- 1 x Twist, Half-Twist or Thumb Throttle & Matching Grip
- 1 x Automatic Cruise Control
- 2 x
Brake Handles w/ Power Cutoff Switch
- 1 x Battery Wire Harness
- 1 x 7-Speed Freewheel (for rear wheel kit only)
- 1 x E-Bike Spoke Wrench
- 1 x Owner's Manual & Installation Instructions
Use the Crystalyte Cruiser (5304) when you're looking for a combination of torque and speed. It handles moderate loads and inclines well -- but it's still very fast. The Cruiser has been tested up to 30 mph (in 13 seconds) at 48V, or 24 mph at 36V.
Top speeds are dependent on rider weight and terrain and vary with wheel size (ie: smaller wheels have slightly slower speeds).
* This kit exceeds limits established by Federal Electric Bike Laws. Classified
as a 'motor vehicle' in most states, this kit is only legal for offroad use unless special safety requirements are fulfilled. License and insurance may also be required. Install and ride the Crystalyte Phoenix at your own risk. For front hub kits, your bike needs to have a very strong fork made of steel. This motor is so powerful it has the potential to rip from the dropouts of an aluminum fork.
Battery Options:
SLA Battery Wiring Kit - $29.99 (need 12V SLA batteries
/ charger)
SLA Wiring Kit w/ Charger - $69.99 - $109.99 (just add 12V SLA batteries)
36V / 12AH Sealed Lead Acid (SLA) Battery w/ Charger - $204.99
48V / 12AH Sealed Lead Acid (SLA) Battery w/ Charger - $284.99
* Battery appearance may vary from the pictures below.
More Crystalyte Phoenix Kit Pictures:
PICTURES OF INSTALLED ELECTRIC BIKE KITS >
|
